Execute a Command over a Unit
While creating a job of this type, choose a command to be executed from
the given list. The list consists of all commands that are configured in
selected units (if you have 'Execute commands' rights to these units).
Not all of selected units may be able to execute a chosen command, and it is seen from the indicator:
a green sign means that all the selected units support this command;
a yellow triangle means that not all the selected units can perform it (see details in the tooltip).
Restrictions can be placed due to access rights or device type used.
For some commands, you should set additional parameters like input/output number, online report interval, etc.
Attention! When the time comes to execute a command as a job, all kinds of rights
are checked beforehand. The user who is a creator of a resource where
the job belongs should have the following access flags to unit: 'Execute
commands' and the set of flags specified in properties of this command.
Related Articles
Unable to Execute a Command
What to do if I cannot execute a command over a unit? Check user's access rights – the flag 'Execute commands' is required. Check if the command is written in unit properties (on the 'Commands' tab). In the properties of the command itself, see which ...Unit ACL
A user can obtain the ability to see a unit on map, track its state (speed, sensor values, etc.), change its properties, execute commands, generate reports about its activity, use unit in jobs and notifications, etc. Standard access rights have been ...Unit Groups
Created units can be formed into groups. Groups are used to unite units on the basis of any criteria. To work with unit groups, choose the corresponding mode in the 'Units' panel. To create a group, click 'Create', fill in general properties, choose ...Unit Group ACL
The set of rights for unit groups is the same as for individual units. The access rights given to a group extend to the units that belong to it. For example, if the right to view commands is given to a user, then the user will be able to see the ...Unit Properties Transfer
Almost any unit properties can be imported and exported: General properties Unit name, device type, phone number(s), unique ID(s), device access password (from the General tab). Icon Icon of the unit and the state of the Rotate icon checkbox. Note ...