Executed Commands

Executed Commands

This kind or report lists all the commands that were sent to a unit and successfully executed. Possible columns are:
  • Sending time — the time when the command was sent to the unit.
  • User — the name of the user who sent the command (hidden if you do not have access rights to the user).
  • Command name — the name of the command as it is written in the unit properties.
  • Command type — the type of the command (see the list).
  • Parameter — the additional parameter in the command (some commands do not have such parameters).
  • Execution time — the time when the command was executed.
  • Channel — the type of connection used to execute the command (TCP, UDP, Virtual, SMS).
  • Count — the number of sent commands.
  • Notes — an empty column for your custom comments.


This is the list of successfully executed commands. To view all the commands sent to the unit regardless of their execution, go to the Messages panel.

More details about the commands can be found in the Commands section.


    • Related Articles

    • Commands

      Required access: View commands — to view this tab and its contents; Create, edit, and delete commands — to create, edit, and delete commands. The Commands tab of the Unit Properties dialog gives possibility to create and configure commands for the ...

    • Commands

      A command is a request that can be sent to a unit. In response, the unit can send its coordinates, take a picture, activate an output, block engine, etc. Available commands depend on the type of device used and its configuration. To be executed, a ...

    • Sent Commands

      The commands sent to the unit by users are displayed on the Sent Commands request. There is a special button in the monitoring panel to send commands to units. The table includes: Time — the time when the command was sent to the unit. User — the ...

    • Commands

      The following commands are supported in gTrack Mobile Client: Query position; Block engine; Unblock engine; Activate output; Deactivate output; Set data transfer interval (how often unit sends data to the server); Send custom message (sending of a ...

    • Unable to Execute a Command

      What to do if I cannot execute a command over a unit? Check user's access rights – the flag 'Execute commands' is required. Check if the command is written in unit properties (on the 'Commands' tab). In the properties of the command itself, see which ...