Registered Events
Different types of events can be registered in the unit history automatically or manually.
Automatic registration is adjusted with the help of notifications (delivery method must be Register event for unit, Register as violation or Register unit status. In such a manner, you can control geofence visits, connection loss, idling, service intervals, etc.
Manually an event can be registered in the special registrar in the monitoring panel. With this method, you can register fuel fillings, maintenance, unit statuses, and any custom event.
Traffic counter reset and routes statuses can be saved as events.
In the table you see:
- the time when the event was detected (automatic registration) or registered (manual registration);
- type: event (traffic counter reset, events from notifications, some custom events, route control statuses), violation (violations from notifications, some custom events), maintenance (registered manually);
- event text which is taken from the text of a notification or from the description entered while registering manually.
Related Articles
Events Registrar
Different events can be registered in the unit history and then shown in the corresponding reports. Some events such as speeding, idling, visits to geofences, sensor values, etc. can be detected automatically by the system with the help of ...Events
All events registered by the system (including violations) can be shown in the report on events. There are different ways to add events to the unit history: Using notifications if themethod of delivery is Register event for unit. Manually using the ...Violations Are Not Registered
I created a notification with action to register a violation. The notification triggers but the violation is not registered. Why? Possible cause is a lack of access to the unit. Required access flag is 'Manage events'. Check if the user (or rather ...GPRS Traffic
This report is executed if a unit has registered events of GPRS traffic counter reset or traffic storage was adjusted with the help of a corresponding job. Time — the time when the counter value was registered. Current value — the value at the moment ...Jobs on Counters
Counters of three types are used in the gTrack tracking system: counters of GPRS traffic, mileage, and engine hours. They can be set up in the unit properties of the unit on the General tab. Jobs about counters allow you to automate the saving of the ...