The following columns can be presented in this kind of report:

• Street: street, roads, highway, etc. name.
  
• Initial location: place where the first messages from this street was received. It can be the same as the previous cell or more detailed (for example, it can additionally contain house number).
  
• Beginning: time when the unit started moving along this street.
  
• End: time when the unit left the street.
  
• Duration: total time the unit was there.
  
• Mileage: distance that was traveled by the unit while moving through this street.
  
• Mileage (adjusted): mileage subject to the coefficient set in advanced unit properties. About mileage in reports...
  
• Avg speed: average speed while moving along this street.
  
• Max speed: maximum speed detected while moving along this street. About speed in reports...
  
• Streets count: the number of performed visits (can be helpful either in grouping table data by years/months/weeks/days/shifts or for the reports on unit groups).
  
• Notes: an empty column for your custom comments.
  

When clicking on a green cell in the table, the map is moved in such a way to display a point where the unit entered or left the indicated street, or reached the maximum speed, and this place is highlighted by a special marker.

Sometimes there can be gaps in cells. It may happen when only one message from a place was received in succession. In such cases, just the name of the street and arrival time are given.

Intervals filtration can be applied to this table: by duration, mileage, engine hours, speed range, trips, stops, parkings, sensors, fuel fillings and thefts. For example, you can get streets where a sensor was on or the streets where a sensor was off.