Counter Sensors
This table shows the operation of the Counter type sensors. In the template, set the mask (filter) for sensors or select All sensors. A table can consist of the following columns:
- Sensor — the name of the sensor.
- Activated — the time of activation.
- Deactivated — the time of deactivation.
- Duration — operation time.
- Total time — the time from the beginning of the first activation to the end of the last.
- Location — the location at the moment of sending the data.
- Mileage — the distance traveled for the operation period.
- Mileage (adjusted) — mileage subject to the coefficient set in the unit properties on the Advanced tab.
- Avg speed — the average speed at this interval.
- Max speed — the maximum speed at this interval.
- Counter — the value of the counter meter (can be shown with an accuracy of hundreds — see Advanced Settings).
- Geofences/Units — the column that includes the names of the geofences or units which were crossed during a given interval. The required geofences and units should be indicated in the filtration parameters. If at some interval there were several geofences or units like that, in the report there will be the name of the geofence with the smallest area or the name of the unit with the smallest radius of approximation. If the sizes coincide, all the names will be included.
- Driver — the name of the driver (if available).
- Trailer — the name of the trailer (if it was bound).
- Penalties — penalties calculated for the adjusted Eco Driving criteria.
- Rank— received penalty points converted into a 6-point rating system.
- Notes — an empty column for your custom comments.
The mileage values are displayed in the table as fractional numbers. However, when exporting to an Excel file the values are rounded.
Intervals filtration can be applied to this table: by duration, mileage, engine hours, speed
range, trips, stops, parkings, sensors, drivers, fuel fillings, fuel
thefts and geofences/units.
The value of the counter sensor can be visualized in the chart that
shows the operation intervals of the counter and its value. You can
learn more about charts here.
Related Articles
Sensors
On the Sensors tab of the Unit Properties dialog, displays a list of all the sensors created for this unit. The table shows the name of the sensor, its type, unit of measure, the parameter on which the sensor is based, description, visibility and ...Digital Sensors
Usually, digital sensors have two states: on/off, activated/deactivated, etc. For example, it can be an ignition or cargo load sensor. All sensors are configured in Unit Properties => Sensors. In the report template you can select up to four sensors ...Validation of Sensors
Validation is configured in the sensor properties and defines interdependence of the sensors. Validator is a sensor whose value affects the current sensor. It is selected from the list of available sensors previously created for the same ...Counters
Access required: Edit counters — to edit current values of counters and calculation methods. Parameters for counters are adjusted on the General tab. Counters are widely used in the system — in online monitoring, as well as in reports. Three types of ...Jobs on Counters
Counters of three types are used in the gTrack tracking system: counters of GPRS traffic, mileage, and engine hours. They can be set up in the unit properties of the unit on the General tab. Jobs about counters allow you to automate the saving of the ...